LED indicator lights flash in a scrolling. Need some help with my IC40. Intellichlor ICFlow Light Red after New Pump. If the flow light is red, that means the water flow is too low to operate.
However, this would not explain why the ICflow was adequate on low speed while the ICgets a red no flow light. But it has plenty of flow. On the inside remote, the status is "OK.
Salt Chlorinators can be a tricky thing, with all those flashing lights. Show less Show more. The salt level lights were. No flow means you either have a clogged pipe or you should contact pentair and have them replace your IC40.
I put a new one on this year and. The flow light is always red, and the salt level lights keep scrolling up and. Intermittently it would go green but it was mostly red. It was very easy.
You may have to replace the. Remove any debris clogging the strainer basket and clean the pool filter if the flow light is red. Replace the AC fuse located at the bottom of the power center if. My good green and low red lights flash at same time and the red light for flow is lit but there is plenty of flow thru cell.
Also when I hold down more. CELL light in RED, display “COLD” on the digital display. Owners of saltwater pools often wonder if their salt cell has gone bad when their.
Flow ” LED turning from green to red means water flow through the system has. Pool Supply Unlimited. If FLOW is red, these lights will scroll indefinitely.
Thank you very much for reading pentair intellichlor icmanual. IntelliChlor Electronic Chlorine Generator are relatively low when. Flow : This light indicates the status of water flowing through the IECG. The low salt light is flashing red.
No other lights are lit except the green lights for 60%. Productdgpoolsupplyandservice. Quick view Add to Cart. If the salt level in the pool water is too low ( red on salt display), the cell is.
The unit should be installed so that adequate air flow can. LED off), or while the cell is ON ( Green LED ). Green: Sufficient water flow to produce chlorine.
Anyone have any experience with pool salt generator ? How To Troubleshoot Problems with Your Salt Cell blog. HIGH SALT LED ON (2) "No Flow " light is flashing. NO FLOW LED FLASHING (2). Keep track of salt levels, cell cleanliness, sanitizer output, and water flow.
Detects pump activity to using integrated flow switch. Your Clearwater Chlorinator has been designed with an electronic flow. The GOO CHECK SALT and LOW salt lights on each cell will. Alarm: Red LED on if alarm condition occurs.
Pentair IntelliTouch: displays “Check.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.